|
TraqDataII allows you to connect analog and
digital inputs and a tach signal input to your Traqmate. It also provides
complete ON/OFF and RECORD/STOP control for a ChaseCam PDR.
- ChaseCam Video Recorder Control - Allows
Traqmate to turn on and off the ChaseCam PDR-100 as well as start and stop
recording synchronously with data recording. This is the same capability as
TraqSync module.
- Four Analog Inputs - Allows Traqmate to
record data from a variety of sensors for driver coaching such as throttle
position and steering angle, or for vehicle tuning such as air-fuel ratio,
oil pressure, or boost pressure. 5, 10, and 20 V ranges are supported.
Sensors are not included.
- Two Digital Inputs / Outputs - Allows
Traqmate to record a digital input such as a brake light or track marker
switch. Allows Traqmate to trigger an external alarm for RPM or an Analog
Input.
- RPM Input - Switchable between COIL and
ELECTRONIC voltage levels to handle almost any application.
The TraqData II package includes the following
items:
TraqData II expansion module with removable 10 connection terminal block.
Contacts are GND, RPM, Digitals 4 and 5, 12V sensor power, Analogs 0-3, and 5V
Reference Voltage.
Snagless 3' Network Cable for connection between TraqData II and ChaseCam
PDR-100. User may substitute longer or shorter network cable for particular
application.
14" DB-15 male to male cable with thumbscrews for connection between Traqmate
Sensor Unit and the TraqData II.
NOTE: This product does not include sensors which must be purchased separately.
See the Traqmate Support Forum for sensor sources.
|
