Cartek 8 Channel Power Distribution Panel
Item Number: CAR-CK-PDP-08 Be the first to review this item
The next generation of Power Distribution
Cartek Motorsport Electronics are pleased to announce the new Power Distribution Panel. This product is a full redesign of their successful but bespoke, Power Control Panels, with the main aim of allowing the user to customise and configure it themselves.
The CARTEK Power Distribution Panel is an all-in-one solid state solution to power distribution in your race car. Designed to replace all the Fuses, Relays and Switches - this unit greatly simplifies the wiring, saving weight and maximising reliability.
-Momentary action (Starter Motor, Washer Pump etc)
-Latching (with memory)
-Latching (without memory)
-Latching with Time Delay (Heated Screen)
-Flashing (Indicators etc)
-Toggling (Headlights High Beam/Low Beam)
-0v Momentary action (use as ordinary switch for ECU Map etc)
Easy to program
Unlike most PDM’s on the market our Power Distribution Panel does not need a laptop to program the configuration. Preset options for functionality and current settings can be chosen by going through a simple process via the switch panel. This saves the user time and any potential labour costs in setting it up.
The CARTEK Power Distribution Panel is one of the most cost-effective solutions on the market due to the switch panel being designed as part of the package, whereas most other PDM’s require expensive CAN-Bus Switch Panels to be purchased and programmed separately.
Customize your own
Two Sticker sets come with every Power Distribution Panel:
1) Multi-coloured Label Set
2) Black and white Label Set
Both Label sets allow back light illumination
CARTEK offer a choice of connection packages, each sold separately.
CK-PDP-CA: One connector and 20 crimped wires (30-50cm wire length)
CK-PDP-LD: One connector and 25 loose crimps (wiring & crimp tool required).
Size: W=140mm, L=145mm
Rear connectors: AMP 1-776231-1, M6 Stud for Power Input
Operating Voltage: 6-12v
Total Output Current: 80 A (Continuous)
Current Settings: 0A, 5A, 10A, 15A, 20A, 25A, 30A
Power Outputs: 8
ECU Inputs: 8
Switch Inputs/Outputs : 8
Battery Isolator XR Signal Inputs: 1
Operating Temperature: -10 -+85
Wiper Control: Dedicated Wiper module with park position input.
Back Light: Low and High power settings
Environmental Protection: Front and Rear Gaskets, protection from Dirt.
Copyright (c) 2018-2019 Stable Energies Inc.
Marketing Solutions by Splendent Studios
Black Friday Special Offer:
Get a FREE Gift Card
with any purchase of $100 or more!
OR Save up to 20% on Gift Certificates!
Offers valid this week only. Expires 11/30/2020.
CLICK HERE to redeem these offers