Cartek Isolator - Battery Isolator XR and Electronic Kill Switch CK-BR-08-B
CAR-CKBR08B
Description
The XR Battery Isolator is the latest generation
of motorsport master-switch devices from
CARTEK.
At 30% smaller size and 40% lighter weight than
the GT isolators, the XR version offers even
more benefits and performance when
compared with traditional mechanical
master-switches and electro/mechanical safety
cut-outs.
FEATURES
When fitted to a race car our Solid State Battery Isolator simultaneously isolates the
battery and kills the engine immediately when triggered in accordance with FiA
safety regulations.
Cartek Battery Isolators can be supplied
unit only
for connection to customers own
switches/buttons or as full kits with high quality, fully waterproof, internal and
external buttons and safety stickers.
This system has been designed to simplify installation thereby saving time and
reducing build costs.
SPECIFICATION
Size:L = 60mm, W = 45mm.
Weight:70g.
Battery negative terminal:M8 stud.
Connector:Binder 09 0415 90 05
Flying Lead:Binder 79 1456 272 05 (2 meter long)
Operational Voltage:7v - 18v
Current consumption:25mA ON, 0.1mA OFF
Battery negative switching current:550-650A Typical, 2000A surge
Engine signal kill current:12v 0.2A when ON, switched to
chassis/earth when OFF
Operating temperature:-10°C - +85°C.
Storage temperature:-40°C - +125°C
To stop the Engine there are two options of Battery Isolator:
GT BATTERY ISOLATOR (Factory ECU'S / PDM's)
The GT Battery Isolator disconnects the negative side of the battery from chassis, as described above, andstops the engine by providing a switched 12v power output which can be used as the main power input to the Ignition or ECU. When the Battery Isolator is switched off and the negative side of the battery has been disconnected it will also cut the 12v output powering your Ignition or ECU thereby stopping the engine. The GT Battery Isolator is designed for cars with no ECU or standard OE ECU.
XR BATTERY ISOLATOR (Aftermarket ECU/PDM/StandAlone Units)
The XR Battery Isolator disconnects the negative side of the battery from chassis, as described above, andstops the engine by outputting an ‘engine stop’ signal which is recognised by most programmable motorsport ECUs and Power Distribution Modules. The ECU or PDM will then shut down when it acknowledges this signal - which then stops the engine.
The latest XR Battery Isolator also features a 0.5 sec time delay between transmitting the engine stop signal and disconnecting the battery allowing ECUs time to perform a shutdown sequence before electrical power is lost.
Cartek Isolator - Battery Isolator XR and Electronic Kill Switch CK-BR-08-B
CAR-CKBR08B