AIM String potentiometer, 10" stroke, 719 4-pin

Item # AIM-LXPA10AIMSP

Easy-to-install AiM Steering Angle Sensor with String Pot design for accurate driver steering input measurement.
Long 10-inch (250mm) travel range with quick connection via 4-pin 719 connector and compatibility with MXL Pista/Pro sensors.
Optimal for racing and automotive applications, ensuring precise calibration and protection from overtravel damage.

$252.00

Quantity

Last items in stock

Description

The standard pulley-type AiM Steering Angle Sensor can be difficult to install in some situations, and an improperly tensioned belt can cause problems. This "string pot" design can be easier to use in many vehicles.

The enclosed* rotary potentiometer is activated by pulling the spring-loaded cable. The very long range allows 10 inches (250mm) of maximum travel to measure and log driver steering input. A 3/16" (4.8mm) eyelet on the end of the cable allows easy connection using a #10 screw. The male 4-pin 719 connector plugs directly into the MXL Pista / Pro sensor harness. The EVO4 requires a 712-719 Patch Cable.

For best results, ensure that the cable will not be pulled out more than 9" (230mm) at full lock. This may prevent a minor bump to the outside front wheel from damaging the sensor due to overtravel. The standard calibration procedure lets you determine where "center" will be.

* Note: This sensor is not sealed against moisture. It must be protected against water and spray.